Interactions of the vector breathers for the coupled Hirota system with $$4\times 4$$ 4 × 4 Lax pair

Nonlinear Dynamics - In this paper, we investigate the interactions of the vector breathers for the coupled Hirota system with $$4\times 4$$ Lax pair. Firstly, we give the first-order breather...     

Organocatalytic asymmetric chlorinative dearomatization of naphthols

An organocatalytic asymmetric chlorinative dearomatization of naphthols was realized for the first time, providing chiral naphthalenones with a Cl-containing all-substituted stereocenter in excellent yields and enantioselectivity (up to 97% yield and 96% ee). The reaction features mild reaction conditions, good tolerance of diverse functional groups and simple reaction operation.     

Designing Covalent Organic Frameworks with a Tailored Ionic Interface for Ion Transport across One-Dimensional Channels

A strategy based on covalent organic frameworks for ultrafast ion transport involves designing an ionic interface to mediate ion motion. Electrolyte chains were integrated onto the walls of one-dimensional channels to construct ionic frameworks via pore surface engineering, so that the ionic interface can be systematically tuned at the desired composition and density. This strategy enables a quantitative correlation between interface and ion transport and unveils a full picture of managing ionic interface to achieve high-rate ion transport. Moreover, the effect of interfaces was scaled on ion transport; ion mobility is increased in an exponential mode with the ionic interface. This strategy not only sets a benchmark system but also offers a general guidance for designing ionic interface that is key to systems for energy conversion and storage.     

A post curing strategy toward the feasible covalent adaptable networks in polyacrylate latex films

The implementation of covalent adaptable networks (CANs) in general resin system is becoming attractive. In this work, we propose a simple post-curing strategy based on the core-shell structured acrylate latex for the achievement on both the improved general performance and the CANs characteristics in latex films. The building to the CANs was relied on the introduction of 4,4′-diaminophenyl disulfide as the curing agent, which cured the acetoacetoxy decorated shell polymer through the ketoamine reaction. The metathesis reaction of aromatic disulfides in the crosslinking segments enabled the thermally induced dynamic behavior of the network as revealed in the stress relaxation tests by comparison with other diamine crosslinking agents without the incorporation of disulfide. The synergism of the dynamic crosslinking of the shell polymer and static crosslinking in the core polymer contributed to the improved mechanical strength (15 MPa, strain% = 250%) and the suppressed water adsorption (~1% in 24 h of soaking) of the latex film, which exhibited above 90% of recovery in both strength and strain from a cut-off film damage within 1 h at 80°C. Moreover, the cured latex film could be recycled, and 75% of the mechanical performance was regained after three fragmentation-hot-pressing cycles. These, in addition with the feasible and environmental friendly characteristics, suggest a sustainable paradigm toward the smart thermosetting latex polymers.     

GZO/Al复合背电极对非晶硅太阳能电池的影响

随着能源紧缺与环境污染问题的日益严重,太阳能的开发利用越来越受到重视,其中非晶硅薄膜太阳能电池由于其制备工艺简单、价格低廉等优点被广泛地研究.为了使非晶硅薄膜太阳能电池得到更好地利用,提高其转换效率和稳定性显得尤为重要.引入复合背电极是提高非晶硅太阳能电池性能的有效手段,其中对GZO/Al复合背电极的研究还未见报道.在该工作中,利用磁控溅射法在非晶硅电池上制备了GZO/Al复合背电极,研究了复合背电极的制备条件及其对非晶硅太阳能电池性能的影响.结果显示,当GZO层的溅射功率为90 W、Al层的溅射功率为90 W时,具有复合背电极的太阳能电池表现出较好的光电转换性能,其短路电流(ISC)、开路电压(VOC)、填充因子(FF)和电池的光电转换效率(η)分别为8.92 mA、1.55 V、54.48;和7.53;.相较于单层Al背电极的太阳能电池,其光电转换效率大幅提高了47.6;(相对效率).     

用标准件对梯度磁场定标

就标准厚度卡片在霍尔传感器的定标方面的应用作了有益的探讨。在纵向测量微小长度时,霍尔片处于磁场边缘位置,其对磁场的梯度更大,即灵敏度更高,且靠中心位置的线性更好。     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

NO分子宏观气体热力学性质的理论研究

采用量子统计系综理论,研究了基态NO分子宏观气体摩尔熵、摩尔内能、摩尔热容等热力学性质.首先应用课题组前期建立的变分代数法(variational algebraic method, VAM)计算获得了基态NO分子的完全振动能级,得到的VAM振动能级作为振动部分,结合欧拉-麦克劳林渐进展开公式的转动贡献,应用于经典的热力学与统计物理公式中,从而计算得到了1000-5000 K温度范围内NO宏观气体的摩尔内能、摩尔熵和摩尔热容.将不同方法计算得到的摩尔热容结果分别与实验值进行比较,结果表明基于VAM完全振动能级获得的结果优于其他方法获得的理论结果.振动部分采用谐振子模型对无限能级求和计算热力学性质的方法有一定的局限性,应当使用有限的完全振动能级进行统计求和.     

Syntheses,crystal structures and properties of Cd(II) and Ag(I) complexes based on 2-p-methylphenyl-5-(2-pyridyl)-1,3,4-thiadiazole

Abstract

Complexes of [CdL₂(NO₃)₂]·1.5H₂O and [Ag₂(μ-L)₂(NO₃)₂] were synthesized by the reactions of 2-p-methylphenyl-5-(2-pyridyl)-1,3,4-thiadiazole (L) with Cd(NO₃)₂·4H₂O and AgNO₃, respectively. Their structures were determined by single crystal X-ray diffraction. The photophysical property and thermal stability were characterized by FT???IR, UV???Vis absorption, fluorescence, and thermogravimetric analysis (TGA). Both complexes belong to the triclinic system with space group p???1. The central metal of [CdL₂(NO₃)₂]·1.5H₂O has a distorted octahedral geometry [CdN₄O₂], while two central Ag(I) atoms of [Ag₂(μ-L)₂(NO₃)₂] exhibit distorted tetrahedral geometries [AgN₃O].